coil

Practicing Safe Sound

There are many ways to upgrade your car audio system and let’s face it, most cars need it. I’m looking at you BMW, VW and Porsche in particular! It is not always possible to upgrade the head unit but it is always possible to improve the speakers. At Car and Home Stereo, we carry speakers by JL Audio, Audison, Hertz, Rainbow and others. This means we can choose the right speaker to suit the car and the customer. We will carefully install your speakers with custom built collars and fittings as well as add sound deadening in the door to improve its acoustic properties. The end result will be a vastly better sound without any cosmetic changes to your car.

And that is where we are finished but before you leave, a word of warning. Please take the time to run your new speakers in. The running in period varies for different speakers but generally, we recommend around 10 hours play time. Running in means keeping the volume at a sensible level without any large bass settings and we will always advise what should be the maximum volume for this period.

If this procedure is not followed your speakers may not fail but they will not reach their full potential, let me explain why.

A speaker is a transducer that converts electrical energy into sound and at the heart of the speaker is a coil of wire sitting inside a magnet. It is bright, shiny copper.

coil speakers good copper

It’s not necessary to know how it works but the important point is that when you pass electricity through a wire heat is generated and the higher the electrical current the more heat is generated. Now, this coil of wire is crucial to the accuracy of the speaker and it is protected by a thin coating of lacquer. This lacquer is quite soft when new and easily damaged by heat but if it is gently warmed over a number of hours the lacquer will harden.

I bet you can see where this is going! If a new speaker is subjected to a lot of power and played loud the voice coil lacquer will boil causing short circuits. Now while this will not necessarily cause the speaker to fail it will mean that the voice coil is not a single continuous wire which leads to a ‘lumpy’ effect within the magnetic gap. This, of course, means that the reproduction of sound is not linear and your investment will not reach its true performance capability. In extreme circumstances, the lacquer is burnt and expands into the magnetic gap which will cause a scratchy sound. These failures are non-reversible, cannot be repaired and are not covered under any warrantee.

 

coil bad burnt copper

burnt copper coil

So that is why we advise the running in period, to gently warm the voice coil lacquer causing it to cure. This hardened lacquer can now stand the heat of high power and your speakers will really perform as the designers intended.

I cannot overstate the importance of running in, a speaker is more likely to be damaged in the first few hours of use rather than over the rest of its life. At Car and Home Stereo, we want you to get the best possible sound from our expert installation so just hold back on the volume for a few hours, you’ll be glad you did.

 

Posted in Car & Home Stereo and tagged , , , , , , , , , , , , , , , .

Leave a Reply

Your email address will not be published. Required fields are marked *